Garage Door Opener Doesn't Open Unless I Hold Down The Button On Keypad.



Question:
I recently had my '84 garage door opener replaced b/c it was noisy and because it would only open slightly when using the remote control. And, to fully open it, I had to crawl under the garage door and use the keypad..mind you, not just punching the button but hold it down until the garage door was fully up. Well, I got a new Genie installed two weeks ago. It *worked* great but now, I've got the same problem! The remote will only lift the door about 2 inches then it stops...even if I hold the open button down. The wall mounted controller opens the door but only if I hold the button down until the door is open. If I simply press the button (like on the remote) it only goes up 2 inches. Any ideas? Help! New garage door opener but same problem!

Answer:
I had the same problem on mine. The door itself is binding and you are holding down the button and forcing the door open. As others have said, you need to unhook the latch from the automatic opener, and open and close the door manually to find where the binding is occurring. Make sure the springs are adjusted for the proper tension, but most likely the problem is in the bearings in the rollers. Check each one and make sure they are properly lubricated, and/or replace them if necessary.





Categories